No Dial Tone - Adtran

No Dial Tone - Adtran

  1. Locate your modem, shown in image, and unplug the power cable. You should see all lights power off.
    1. Warning: This will take down the internet service until power is restored to the modem.
  2. Verify your modem cables are connected properly

    1. Phone cable - Verify that the phone cable is connected in the phone port on the modem. Verify that the cable goes to the wall jack or phone base.
    2. Wall Jack - Verify that the wall jack is secure and not loose. Make sure there are no exposed wires.

  3. Plug the modem power cable back in.
    1. Notice: The lights on the modem will flash and light up. Allow the modem up to 5 minutes to finish processing.
  4. Attempt to make a test call from the home phone to your cell phone or a neighbor.
  5. Do you still not have dial tone? Please contact us for more troubleshooting.

    • Related Articles

    • No Dial Tone - Calix

      Locate your modem, shown in image, and unplug the power cable. You should see all lights power off. Warning: This will take down the internet service until power is restored to the modem. Verify your modem cables are connected properly. Phone cable - ...

    • Adtran Slow Speeds

      Experiencing slow speeds on your Adtran / Plume system? This guide is here to help! We understand how frustrating lag and buffering can be so our goal is to get you back and connected with good speeds once again. Locate your ONT (Optical Network ...